Page 1
® products with a watertight reputation AQ-MP-5BT-H - WATERPROOF MEDIA PLAYER for Bluetooth & MP3 devices USER / INSTALLATION MANUAL Replaces Factory Radio on Harley-Davidson Motorcycles ® (Models 1998-2013) charging Aquatic AV 282 Kinney Drive San Jose, CA 95112, USA E-mail: info@aquaticav.com...
Table of Contents FCC Statement Media Player AQ-MP-5BT-H Media Player AQ-MP-5BT-H 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following 1 Getting Started......................... two conditions: 1.1 Contents..........................(1) This device may not cause harmful interference,and 1.2 Connections........................
Allows connection of the wired Remote Control (AQ-WR-5F sold separately) RF receiver. limitations on the length of an implied warranty, so this limitation may not apply. No person is authorized to assume for Aquatic AV any other liability in connection with the sale of the product. 6. Bluetooth Antenna Allows a Bluetooth device to wirelessly connect to the unit.
Getting Started Specifications & Dimensions Media Player AQ-MP-5BT-H Media Player AQ-MP-5BT-H 6.1 Specifications 1.3 Wiring Diagram Media Supported media........Bluetooth/MP3/FM/AM FM Frequency Range......87.5MHz – 107.9MHz(USA)/87.5MHz - 108MHz(E UR) AM Frequency Range......526.5KHz – 1606.5 KHz Bluetooth Operation Frequency range..2402 – 2480MHz Bluetooth Output Power(MAX)<10dBm...
Settings Operation Getting Started Media Player AQ-MP-5BT-H Media Player AQ-MP-5BT-H 5.7 Beep Tone 1.4. Mounting Precautions Beep tone plays when any button is pressed, it can be toggled on and off from this selection. Please observe the following precautions: 5.8 System Reset 1.
2. Locate the stock 35-pin wiring harness that was connected to your OEM radio. This connector signal from. will not be connected to your Aquatic AV head unit. Cut the four matching colored wires from the back of the 35 pin harness 3” down from the connector.
FM frequency in steps of 0.05 MHz, e.g. 88.25, 88.30, 88.35 MHz. 1.9 Power On The AQ-MP-5BT-H requires +12V DC to both the red and yellow wires. When both of these wires have power the AQ-MP-5BT-H is powered on. Ground is connected to the black wire.
3.1.1 Pair with Bluetooth Device 1. Switch on your Bluetooth device. 2. Select ‘AQUATIC AV’ from the list of available devices to pair (no password is needed). 3. A Bluetooth logo will illumiate on the Media Player LCD to verify Bluetooth is activated.