Advertisement
Adding fluid to the Track Cleaner reservoir (continued)
2. Unscrew the reservoir bottle. Leave the cap connected to the car by the tube.
3. Add track cleaning fluid to the reservoir bottle, filling it about half way.
4. Hold the car vertically and screw the reservoir bottle back into the cap. Refer to Figure 2.
5. Holding the car horizontally, slide the fluid applicator lever to the ON position and squeeze
the reservoir to remove any air bubbles from the system.
Excess fluid may flow out of the car. Hold the car over your sink or rest it on a towel
Note!
to avoid saturating your layout.
6. Slide the fluid application lever back to the OFF position after a few drops of cleaning fluid
have been forced into the cleaning ring.
7. Replace the body by sliding the front tab into position and then snapping down the two
rear posts.
Figure 2. Reservoir installation
Top
Reservoir bottle
4
Bottom
Advertisement
