Lionel Truss Bridge with Flasher and Piers Owner's Manual
  1. Manuals
  2. Brands
  3. Lionel Manuals
  4. Toy
  5. Truss Bridge with Flasher and Piers
  6. Owner's manual

Lionel Truss Bridge with Flasher and Piers Owner's Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

20130130250
3/21
Lionel
Truss Bridge
with Flasher and Piers
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Truss Bridge with Flasher and Piers and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Lionel Truss Bridge with Flasher and Piers

Summary of Contents for Lionel Truss Bridge with Flasher and Piers

  • Page 1 20130130250 3/21 Lionel Truss Bridge with Flasher and Piers Owner’s Manual...
  • Page 2 Thank You! hank you on your purchase of the Lionel Truss Bridge with Flasher and Piers! We recommend that you use an Elevated Trestle Set (available separately) or a Graduated Trestle Set (available separately) to bring your O or O-27 gauge track up to the height of the Truss Bridge.
  • Page 3 Assembling the Truss Bridge Follow these steps to assemble the Truss Bridge. Note! If you choose to permanently assemble the Truss Bridge, you may apply any cement intended for use with plastic kits (not included). As illustrated in Figure 1, fit the steel base into the slot on the inside of the side structures. Secure the base to the side structures using the flat-head screws, two on each side.
  • Page 4 Assembling the Truss Bridge continued As illustrated in Figure 3, slide the four support sections into the grooves in the side structures. Support sections Groove Figure 3. Installing the support sections Snap the two top structures onto the pins on the side structures. Refer to Figure 4. Figure 4.
  • Page 5 Assembling the Truss Bridge continued Press the lamp housing tabs into the gap between the two top sections and feed the wires into the structure. Refer to Figure 5. Figure 5. Installing the lamp housing After the wires are inserted through the top, route each wire through one of the support sections, down the side structures, and through the metal base as shown in Figure 6.
  • Page 6 Run your straight sections of FasTrack or traditional O or O-27 gauge track (available separately) across the bridge. You may choose to use a Lionel Elevated Trestle Set (available separately, 6-12755 for O and O-27 gauge layouts, 6-12038 for FasTrack layouts) or a Graduate Trestle Set (available separately, 6-12754 for O and O-27 gauge layouts, 6-12032 for FasTrack layouts) to bring the track to the Truss Bridge.
  • Page 7 1. Connect one wire to the Power/A terminal on your power supply OR to the #1 terminal on a Lionel Lockon (available separately, 6-62900). Refer to Figure 8. 2. Attach the other wire to the Common/Ground/U terminal on your power supply OR to the #2 Lockon terminal.
  • Page 8 Lionel LLC or any Lionel Authorized Service Station MUST be accompanied by the original receipt for purchase (or copy) from an Authorized Lionel Retailer*, will at the discretion of Lionel LLC, be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a suitable replacement is not available, Lionel will offer to replace the product with a comparable model (determined by Lionel LLC), if available.

Table of Contents