Perkins 1204EA-E44TA Operation And Maintenance Manual page 47

M0135751
(Table 3, contd)
Factory Installed Aftertreatment #1 Identification Number
DPF #1 Soot Loading Sensing System Configuration Code
Limp Home Engine Speed Ramp Rate
System Operating Voltage Configuration
Rating Number
CAN Communication Protocol Write Security
Engine Emissions Operator Inducement Progress Configuration
Engine Emissions Operator Inducement Regulation Configuration
Customer Specified Parameters
Customer specified parameters allow the engine to
be configured to the exact needs of the application.
The electronic service tool is required to alter the
customer configuration parameters.
Customer parameters may be changed repeatedly as
operational requirements change.
Table 4
Specified Parameters
Throttle Type Channel 1
Throttle Type Channel 2
IVS Channel 1
IVS Channel 2
Continuous Position Throttle Configuration 1
Continuous Position Throttle Configuration 2
Multi Position Throttle Switch Configuration
Throttle Arbitration
Equipment ID
Low Idle Speed
Ether Solenoid Configuration
Engine Idle Shutdown Minimum Ambient Air Temperature
Engine Idle Shutdown Maximum Ambient Air Temperature
Engine Idle Shutdown Enable Status
Engine Idle Shutdown Delay Time
Engine Idle Shutdown Ambient Temperature Override Enable Status
High Soot Load Aftertreatment Protection Enable Status
Air Shutoff
Customer Specified Parameters
Operation Section
Configuration Parameters
Record
(continued)
47