Replacing The Oven Light Bulb; Changing Halogen Bulbs; Changing The Door Seal - NEFF B46W74.0GB Instruction Manual

Hide thumbs Also See for B46W74.0GB:
Table of Contents

Advertisement

Replacing the oven light bulb

Replace faulty oven light bulbs.
You can obtain replacement light bulbs from customer service
or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to
300 °C. Only use these oven light bulbs.
ã=
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
Place a tea towel in the cold cooking compartment to prevent
1.
damage.
Turn the glass cover anticlockwise and remove it.
2.
Replace the oven light bulb with a bulb of the same type.
3.
Screw on the glass cover again.
4.
Remove the tea towel and switch on the circuit breaker.
5.
Note: If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)

Changing halogen bulbs

Replace faulty halogen bulbs. You can obtain replacement light
bulbs from the after-sales service or from specialist retailers:
Osram Ministar Axial Reflector 12 V - GY 6.35; 20 W. Only use
these bulbs.
ã=
Risk of burns!
Halogen bulbs become very hot when switched on. When
replacing them, wait until the bulb has cooled down.
Caution!
Clouding in halogen bulbs: Do not touch halogen bulbs with
bare fingers. This causes oils to get onto the glass which are
then burnt on and cloud the glass. Use a clean cloth to change
the bulb.
Remove the appliance door (see section: Removing and
1.
refitting the appliance door).
Remove the door panel (see section: Cleaning the door
2.
panels).
The halogen bulbs are located on the left- and right-hand
sides next to the door hinges (Fig. A).
Unclip the bulb fitting and halogen bulb from the holder and
3.
remove it (Fig. B).
$
Change the halogen bulb. Use a clean cloth.
4.
Insert the halogen bulb and bulb fitting into the appliance
5.
door.
Fit the door panel and appliance door.
6.
%

Changing the door seal

If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
Unhooking the door seal
The door seal is fixed in nine places.
Unhook (Fig. B) the door seal at four points (Fig. A).
1.
$
Hook the door seal in at five further points (Fig. C) by turning
2.
the hooks slightly (Fig. D).
&
Hooking in the door seal
Hook (Fig. B) the door seal in at four points (Fig. A).
1.
Hook the door seal in at five further points (Fig. C) by turning
2.
it slightly (Fig. D).
Check that the door seal is seated correctly.
3.
%
'
29

Advertisement

Table of Contents
loading

Table of Contents