Changing The Operating Mode; Changing The Temperature; Switching Off The Appliance; Rapid Heat Up - NEFF B46W74.0GB Instruction Manual

Notes
The EasyClean® and Dough proving operating modes can
■
only be started when the appliance has cooled down.
You can only start low-temperature cooking if neither
■
"Residual heat high" nor "Residual heat low" is shown in the
text display.
Steam cooking can only be started when the cooking
■
compartment has cooled down or "Residual heat low"
appears in the text display.
If no default temperature is displayed, the temperature of your
■
selected operating mode is a fixed setting. You cannot
change this temperature.
Operating mode
CircoTherm®
Defrost setting
Top/bottom heat
Circotherm intensive
Bread-baking
Bottom heat
Circo-roasting
Full-surface grill
Full-surface grill
(intensive)*
Centre-area grill
Centre-area grill
(intensive)*
Low-temperature cooking Fixed setting
Steam cooking
Dough proving
Plate warming
Keep warm
Sabbath programme
Oven cleaning
Oven lighting
* Increase the temperature to over 275 °C until "Intensive"
appears in the text display.
Current temperature
While the oven is heating up, touch the
temperature is shown for as long as you touch the button.
If no current temperature appears in the text display, the
appliance is heated up.
Heating indicator
The heating indicator displays the rising temperature in the
cooking compartment.
Temperature reached (fig. A)
■
Appliance reheating (fig. B)
■
$

Changing the operating mode

Changing the operating mode while the appliance is in
operation.
Touch the button.
m
1.
8
Default Temperature
temperature in range in °C
°C
160 40 - 200
Fixed setting
170 50 - 275
220 50 - 275
200 180 - 220
200 50 - 225
170 50 - 250
220 50 - 275
Fixed setting
180 50 - 275
Fixed setting
Fixed setting
Fixed setting
Fixed setting
85 60 - 120
Fixed setting
Fixed setting
Fixed setting
² button. The current
%
Scroll the NeffNavigator® in order to select the desired
2.
operating mode.
or
Touch the , or button in order to select the operating
3 % (
mode directly.
Touch the button.
m
3.
The appliance applies the set operating mode.

Changing the temperature

Changing the temperature while the appliance is in operation.
Touch the button.
[
1.
or
Press NeffNavigator® down.
Scroll the NeffNavigator® until the desired temperature is
2.
selected.
Your setting is accepted after 3 seconds.

Switching off the appliance

Press and hold the button for 2 seconds.
~
The appliance is switched off.

Rapid heat up

You can reduce the preheat time for the CircoTherm® or
Bread-baking operating modes if the set temperature is higher
than 100° C.
Note: During rapid heat up, do not place any food in the
cooking compartment while the
Set the operating mode and temperature, and start.
1.
Touch the button.
R
2.
The button lights up and "Rapid heat up" appears in the
R
text display.
After reaching the set temperature, rapid heat up switches off.
The R button and "Rapid heat up" go out in the text display
and a signal sounds.
Cancelling rapid heat up
Touch the button. The
R R
in the text display.

Personal programmes

The appliance offers you the option to record, save and play
back personal programmes. In your personal programme, you
can record the cooking process for elaborate food or your
favourite dishes in programme steps, e.g. for lasagne:
Step 1: 50 minutes with CircoTherm® at 160 °C
Step 2: 5 minutes on full-surface grill at 275 °C
A maximum of 25 personal programmes can be saved.
Recording
Only begin the recording when the cooking compartment is
cold. The recording must be at least one minute long in order
for it to be saved.
Press and hold the button for 1 second.
~
1.
Touch the button.
Y
2.
Push the NeffNavigator® down in order to go to the
3.
"Personal programmes" menu.
Push the NeffNavigator® down in order to select
4.
"New programme".
Scroll the NeffNavigator® in order to select the operating
5.
mode for "New programme step 1" (e.g. CircoTherm), and
push down.
Scroll the NeffNavigator® if necessary in order to change the
6.
default temperature for "Step 1" (e.g. 160 °C).
button is illuminated.
f
button and "Rapid heat up" go out