Table of Contents
Advertisement
Problem
Once you have switched on an operating
mode,
•
or
œ
appears on the temperature
display, and "Not possible" appears on the
text display
The appliance has switched off automati-
cally. "Safety switch-off" appears in the text
display,
:
flashes in the temperature
‹
‹‹
display
Smoke is generated during roasting or
grilling
Higher levels of condensation are gener-
ated in the cooking compartment
Enamelled accessories have light, matt
marks
Door panels are misted up
Replacing the oven light bulb
Replace faulty oven light bulbs.
You can obtain replacement light bulbs from customer service
or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to
300 °C. Only use these oven light bulbs.
ã=
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
Place a tea towel in the cold cooking compartment to prevent
1.
damage.
Turn the glass cover anticlockwise and remove it.
2.
Replace the oven light bulb with a bulb of the same type.
3.
Screw on the glass cover again.
4.
Remove the tea towel and switch on the circuit breaker.
5.
Note: If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)
Changing halogen bulbs
Replace faulty halogen bulbs. You can obtain replacement light
bulbs from the after-sales service or from specialist retailers:
Osram Ministar Axial Reflector 12 V - GY 6.35; 20 W. Only use
these bulbs.
ã=
Risk of burns!
Halogen bulbs become very hot when switched on. When
replacing them, wait until the bulb has cooled down.
Caution!
Clouding in halogen bulbs: Do not touch halogen bulbs with
bare fingers. This causes oils to get onto the glass which are
then burnt on and cloud the glass. Use a clean cloth to change
the bulb.
Possible cause
The appliance has not cooled down fully
The appliance has switched off to protect
itself from overheating
Fat is burning on the grill element
Wire rack or universal pan inserted incor-
rectly
Normal occurrence (e.g. when baking
cakes with very moist toppings or roasting
a large joint)
Normal occurrence caused by dripping
meat or fruit juices
Normal occurrence caused by tempera-
ture differences
Remove the appliance door (see section: Removing and
1.
refitting the appliance door).
Remove the door panel (see section: Cleaning the door
2.
panels).
The halogen bulbs are located on the left- and right-hand
sides next to the door hinges (Fig. A).
Unclip the bulb fitting and halogen bulb from the holder and
3.
remove it (Fig. B).
$
Change the halogen bulb. Use a clean cloth.
4.
Insert the halogen bulb and bulb fitting into the appliance
5.
door.
Fit the door panel and appliance door.
6.
Changing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
Unhooking the door seal
The door seal is fixed in nine places.
Unhook (Fig. B) the door seal at four points (Fig. A).
1.
$
Remedial action
Wait until the appliance has cooled down,
then switch on the operating mode again
Turn the operating mode selector back to
the
position
Û
Continue grilling or roasting until the fat on
the grill element is burnt away
Place the wire rack in the universal pan
and insert them together at a lower shelf
height
Open the appliance door briefly from time
to time during operation
Not possible
Heat the appliance up to 100 °C and then
switch off again after 5 minutes
%
%
29
Advertisement
Table of Contents
