Table of Contents
Advertisement
Rails
en
First rinsing cycle
Open the control panel.
1.
Remove the water tank, rinse thoroughly, fill with
2.
water and reinsert.
Close the control panel.
3.
Press the l Start/Stop button to start.
4.
The appliance rinses.
Once the duration has elapsed, an audible signal
sounds.
Second rinsing cycle
Open the control panel.
1.
Remove the water tank, rinse thoroughly, fill with
2.
water and reinsert.
Close the control panel.
3.
Press the l Start/Stop button to start.
4.
The appliance rinses.
Once the duration has elapsed, an audible signal
sounds.
Rinsing
Open the control panel.
1.
Empty and dry the water tank.
2.
Press the # On/Off button to switch off the
3.
appliance.
Descaling is complete and the appliance is ready for
use again.
pRails
W ith good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
:
Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Detaching the rails
Lift the rail slightly at the front ‚ and detach it ƒ
1.
(figure
).
!
Then pull the whole rail towards you and take it out
2.
(figure
).
"
32
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Attaching the rails
The rails only fit on the right or the left side. The pull-out
rails must pull out towards you.
First, insert the rail in the middle of the rear socket ‚,
1.
until the rail rests against the cooking compartment
wall, and push it back ƒ (figure
Then insert the rail into the front socket „, until the
2.
rail also rests against the cooking compartment wall
here, and press it downwards ... (figure
qAppliance door
W ith good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
appliance door and clean it.
Removing and fitting the appliance door
For cleaning purposes and to remove the door panels,
you can detach the appliance door.
The appliance door hinges each have a locking lever.
When the locking levers are closed (figure
appliance door is secured in place. It cannot be
detached.
When the locking levers are open in order to detach the
appliance door (figure
"
cannot snap shut.
:
Warning
Risk of injury!
If the hinges are not locked, they can snap shut with
■
great force. Ensure that the locking levers are always
fully closed or, when detaching the appliance door,
fully open.
Risk of injury!
).
!
).
"
), the
!
), the hinges are locked. They
Advertisement
Table of Contents
