Table of Contents
Advertisement
ATEX Declaration of Conformity ATEX 防爆认证
Equipment, components and protection systems for use for their intended purpose in explosion protected
zones – Directive RL 94/9/EC (ATEX)
Document number:
Product designation:
Manufacturer:
Product description:
The conformity assessment process was conducted in compliance with Directive 94/9/EC (ATEX). The
results are recorded in the confidential Test Report TD-610-22-3. All related documents are kept at the
centres named below:
QS Zürich AG, named centre CE 1254
Wehntalerstrasse 3
CH-8057 Zürich
COLASIT hereby certifies compliance with the basic health and safety requirements for the design and
manufacture of equipment and protection systems for use for their intended purpose in explosive
atmospheres in compliance with Annex II of the Directive.
The following harmonised standards were applied:
EN 1127-1: Explosive atmospheres – Explosion protection, Part 1, 2012
EN 13463-1: Non-electrical equipment for potentially explosive atmospheres, Part 1, 2009
EN 13463-5: Non-electrical equipment for potentially explosive atmospheres, Part 5, 2011
EN 14986:
Design of fans working in potentially explosive atmospheres, 2007
The marking on the appliance must comprise the following information:
II 3/- G
II 3/3 G c T3 or c T4 (conveyed medium Zone 2, site of installation Zone 2)
II 2/3 G c T3 or c T4 (conveyed medium Zone 1, site of installation Zone 2)
II 2/2 G c T3 or c T4 (conveyed medium Zone 1, site of installation Zone 1)
The associated operating instructions contain important safety instructions and regulations for putting the
named equipment into operation in compliance with Directive 94/9/EC (ATEX).
Changes to the named equipment are prohibited except with the manufacturer's express approval in writing.
If the named equipment is built into a higher level machine, the new risks ensuing from the integration must
be assessed by the manufacturer of the new machine.
th
Spiez, 5
December 2012
ATEX Officer
Page 29
Editione 2013 / Subject of alteration
Copyright by COLASIT AG Spiez
ATEX Declaration of Conformity
TD-000 807
High pressure radial fan CHVS 63-250 ATEX
COLASIT AG
Postfach 85
3700 Spiez
Plastic industrial fan for the conveyance of chemically
agressive gases, vapour or correspondingly contaminated air.
c T3 or c T4 (conveyed medium Zone 2, site of installation no zone)
On behalf of the executive management
Phone +41 (0)33 655 61 61 Fax +41 (0)33 654 81 61
COLASIT AG
Plastic construction
CH-3700 Spiez
Advertisement
Table of Contents
