Download Print this page
Exmark LAZER Z S Series Setup Instructions
Hide thumbs Also See for LAZER Z S Series:

Advertisement

Quick Links

This product contains a chemical or chemicals known to the State of California to
The engine exhaust from this product contains chemicals known to the State of California
Loose Parts
Use the chart below to verify that all parts have been shipped. Part numbers not shown are available on the dealer
extranet.
Dealer Pack
Part #
104-8301
3231-7
103-2106
1-603511
Literature Pack
Manual, Operator's
Manual, Engine Operator's
© 2013—Exmark Mfg. Co., Inc.
P.O. Box 808
Beatrice, NE 68310
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
to cause cancer, birth defects, or other reproductive harm.
Description
Nut-Nyloc 3/8-16 Flg
Bolt-Carriage 3/8-16 x 2 1/4
Key, Exmark Logo
Key, Standard
WARNING
CALIFORNIA
Qty.
3
3
1
1
LAZER Z
S-SERIES
®
Setup Instructions
For Serial Nos. 314,000,000 & Higher
Use
Installing the side bumpers (Rear
Discharge Units Only).
Fill out the online warranty registration
form and place keys into literature
pack.
All Rights Reserved *4501-743* B
Part No. 4501-743 Rev. B
Printed in the USA.

Advertisement

loading

Summary of Contents for Exmark LAZER Z S Series

  • Page 1 Key, Standard 1-603511 pack. Literature Pack Manual, Operator's Manual, Engine Operator's © 2013—Exmark Mfg. Co., Inc. All Rights Reserved *4501-743* B Part No. 4501-743 Rev. B P.O. Box 808 Printed in the USA. Beatrice, NE 68310...
  • Page 2 Raise the Rollover Protection Important: The machine is shipped with a filled lead acid battery. System (ROPS) 1. Pull the knob and rotate 90° to the unlatched DANGER position (see Figure 1). Charging or jump starting the battery may produce explosive gases.
  • Page 3 The engine is shipped with oil; check oil level and if continuously for 20 to 30 minutes to sufficiently necessary fill to the appropriate level. Exmark 4-Cycle charge the battery. Premium Engine Oil is recommended. Refer to the Engine Owner’s Manual for an acceptable alternative.
  • Page 4 Note: The oil level on the dipstick will be incorrect if the oil is checked when the unit is hot. 5. If the dipstick oil level is at the “add” mark add Exmark Premium Hydro oil. 6. Replace hydraulic reservoir cap and tighten until snug. Do Not overtighten.