Exmark OCD02 Operator's Manual
  1. Manuals
  2. Brands
  3. Exmark Manuals
  4. Lawn Mower Accessories
  5. OCD02
  6. Operator's manual
Exmark OCD02 Operator's Manual

Exmark OCD02 Operator's Manual

Operator controlled discharge
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
OCD02
Part No. 4500-482 Rev. B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OCD02 and is the answer not in the manual?

Questions and answers

Related Manuals for Exmark OCD02

Summary of Contents for Exmark OCD02

  • Page 1 OCD02 Part No. 4500-482 Rev. B...
  • Page 2 Exmark reserves the right to make changes or add improvements to its products at any time without incurring any obligation to make such changes to products manufactured previously. Exmark, or its distributors and dealers, accept no responsibility for variations which may be...

  • Page 3: Introduction

    All Exmark parts are thoroughly tested and inspected before leaving the factory, however, attention is required on your part if you are to obtain the fullest measure of satisfaction and performance.

  • Page 4: Table Of Contents

    Safety Alert Symbol ... 5 Safe Operating Practices ... 5 Safety and Instructional Decals ... 7 Setup ... 8 Installing OCD02 on Mower Deck... 8 Product Overview ... 10 Operation ... 11 Opening the Discharge Gate... 11 Closing the Discharge Gate... 11 Maintenance ...

  • Page 5: Safety

    Safe Operating Practices Training • Read the OCD02 and tractor Operator’s Manuals and other training material. If the operator(s) or mechanic(s) can not read English it is the owner’s responsibility to explain this material to them.
  • Page 6 Safety – Before clearing blockages. – Whenever you leave the mower. WARNING Hands, feet, hair, clothing, or accessories can become entangled in rotating parts. Contact with the rotating parts can cause traumatic amputation or severe lacerations. • Do Not operate the machine without guards, shields, and safety devices in place and working properly.

  • Page 7: Safety And Instructional Decals

    109-9928 • New safety signs may be obtained from your authorized Exmark equipment dealer or distributor or from Exmark Mfg. Co. Inc. • Safety signs may be affixed by peeling off the backing to expose the adhesive surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.

  • Page 8: Setup

    Setup Setup Installing OCD02 on Mower Deck Important: For Serial Numbers 790,000 and higher, multiple accessories added to a base unit can change the stability of the machine. Read the unit operator’s manual to determine if counterbalance weights are necessary for the accessories installed on the unit.
  • Page 9 9. Place the cable into the cable bracket notch and secure with the two nuts. Make sure the nuts are centered on the bracket. 10. Wrap the cable hanger strap over the cross shaft and feed the loose end of the cable through the strap holes as shown in Figure 5.

  • Page 10: Product Overview

    Product Overview Figure 8 1. Foot pedal 7. Gate lift link 2. Push down 8. Hairpin 3. Rear cover notch 9. Deck mount bracket 4. Cover 10. Cable nuts 5. Side cover notch 11. Knob 6. Cable 12. Link pivot bracket in unlocked position 14.

  • Page 11: Operation

    Operation Important: Always mow with the discharge deflector installed and in the down position. DANGER An uncovered discharge opening will allow objects to be thrown in an operator’s or bystanders’s direction. Also contact with the blade could occur. Thrown objects or blade contact can cause serious injury or death.

  • Page 12: Maintenance

    Maintenance Maintenance Note: Determine the left and right sides of the machine from the normal operating position. WARNING While maintenance or adjustments are being made, someone could start the engine. Accidental starting of the engine could seriously injure you or other bystanders. Remove the key from the ignition switch, engage parking brake, and pull the wire(s) off the spark plug(s) before you do any...

  • Page 13: Troubleshooting

    The following table lists some of the common causes of trouble. If assistance is needed, contact your Exmark Service Dealer. Note: When disconnecting electrical connectors Do Not pull on the wires to separate the connectors.
  • Page 14 • Attorney's fees. No Claim of breach of warranty shall be cause for cancellation or rescission of the contract of sale of any Exmark attachment or accessory. All implied warranties of merchantability (that the...

  • Page 15: Service Record

    Service Record Date: Description of Work Done: Service Done By:...
  • Page 16 SEE EXMARK’S COMPLETE LINE OF ACCESSORIES AND OPTIONS MID-MOUNT RIDING ACCESSORIES AND OPTIONS CUSTOM RIDE SEAT SUSPENSION SYSTEM FULL SUSPENSION SEAT DECK LIFT ASSIST KIT HITCH KIT LIGHT KIT V POWER PORT MICRO-MULCH SYSTEM OUT-FRONT RIDING ACCESSORIES AND OPTIONS CUSTOM RIDE SEAT SUSPENSION SYSTEM...

Table of Contents

Save PDF