Ibration Damping System - Husqvarna 545 Workshop Manual

Assembly
1. Thread the throttle cables in the connection
as outlined in figure 55.
shown from underneath.
2. Run the fuel hose
and C in hole L. See figure 55. Pull the
hoses so that the collars are on each side of
the bottom on the carburettor compartment.
3. Tighten the chain catcher in place.
4. Press the movement limiter
figure 53.
5. Tighten the screws F. See figure 51.
6. ook on the throttle cable E in the intake bel-
low. See figure 50.
7. Fit the tank unit. The two short screws are fitted
to the bottom of the handle bar.
8. Assemble the carburettor as outlined in As-
sembling the carburettor . Assemble the air
filter and cylinder cover.
7.17 Vibration damping system
Dismantling
1. ismantle the following parts
• ar and chain. See the
• Cylinder cover. See the
• Tank unit and handle. See
tank unit .
2. ismantle the spring on the handle bar using a
4 mm Allen key (see figure 57).
3. ismantle the springs on the tank unit using
a 4 mm Allen key (tool 502 50 18-01). See
figure 57.
Cleaning and inspection
Clean and inspect all parts.
Assembly
1. Fit the springs on the handle bar using a 4 mm
Allen key (tool 502 50 18-01).
2. Assemble the following parts
• Tank unit and handle. See Assembling the
tank unit .
• Cylinder cover. See the
• ar and chain. See the
TE The figure is
through hole and hoses
into position. See
perator s anual.
perator s anual.
ismantling the
perator s anual.
perator s anual.
Fig 54
Fig 55
Fig 56
Fig 57
Repair Instructions
45
English -