To Do A Check Of The Vibration Damping System; To Do A Check Of The Start/Stop Switch; To Do A Check Of The Muffler - Husqvarna T525 Operator's Manual

To do a check of the throttle trigger and the
throttle trigger lockout
1. Make sure that the throttle trigger and throttle trigger
lockout move freely and that the return spring works
correctly.
2. Push down the throttle trigger lockout and make sure
that it goes back to its initial position when you
release it.
3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the chainsaw and apply full throttle.
5. Release the throttle trigger and make sure that the
saw chain stops and stays stationary.
WARNING: If the saw chain rotates
when the throttle trigger is in the idle
position, speak to your servicing dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
1007 - 003 - 28.08.2019
2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the vibration damping
system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.

To do a check of the start/stop switch

1. Start the engine.
2. Push the start/stop switch to the STOP position. The
engine must stop.

To do a check of the muffler

1. Loosen the screw to the muffler guard.
19