Husqvarna 545 Workshop Manual page 61

8
Assemble the following parts
A. Tank unit.
. Piston and cylinder.
C. uffler.
. Carburettor.
E. Centrifugal clutch.
F. Electrical System.
. Starter.
. ar and chain.
Sealing rings
1
To replace the crankshaft s sealing rings, first dis-
mantle the following parts
n the flywheel side
• Starter.
• Flywheel.
n the clutch side
• ar and chain.
• Chain guide plate.
• Centrifugal clutch.
• il pump.
2
Use a screwdriver to remove the sealing ring and
pull it out.
3
Slide the dowel 575 34 69-01 (figure 80) on the
crankcase pin. nock the new sealing ring in place
using the 575 34 70-01 tool. See Figure 81.
NOTE! Excessively hard impact can move the
bearing. Therefore, support the outer race of
the bearing when fitting a new sealing ring.
4
Fit the parts as outlined in point 1 above.
Fig 80
Fig 81
Repair Instructions
61
English -