Location - Hatco HDW-1 Installation & Operating Manual

INSTALLATION
Model (D) Depth (W) Width
Dimension Dimension
HDW-1B 23-3/4"
(60 cm)
HDW-2B 23-3/4"
(60 cm)
HDW-3B 23-3/4"
(60 cm)
HDW-1BN 28-1/8"
(71 cm)
HDW-2BN 28-1/8"
(71 cm)
HDW-3BN 28-1/8"
(71 cm)
a lock strip (not supplied by Hatco) must be perma-
nently fastened to the lower front inside lip of the
cabinet opening. See Figure 7.
5. Partially insert the Drawer Warmer into the opening,
making sure the flexible conduit is fed into the wire
connection area first. Have a qualified electrician
connect the wires at this time.
!
WARNING
Final electrical connections must be made by a quali-
fied electrician.
6. Before completely installing the unit into the open-
ing, apply a bead of NSF approved sealant between
the Drawer Warmer flange and the cabinet facing.
7. Slide the unit completely into the opening until front
locking studs drop behind locking strip and lock into
place. To verify installation, pull bottom drawer fully
out and gently pull to ensure unit is securely locked
in place.
Printed March 1999
(H) Height
Dimension
28-5/16" 10-1/8"
(72 cm) (26 cm)
28-5/16" 20-1/4"
(72 cm) (51 cm)
28-5/16" 30-3/8"
(72 cm) (77 cm)
19-5/8" 10-1/8"
(50 cm) (26 cm)
19-5/8" 20-1/4"
(50 cm) (51 cm)
19-5/8" 30-3/8"
(50 cm) (77 cm)
Figure 7. Built-In Cutout Dimensions
Section A-A
"
.5
(1 cm)
D
H
Lock Strip
"
.125
"
.875
(.5 cm)
(2 cm)
Drawer Bezel Outline

LOCATION

!
Locate the unit in an area that is convenient for use.
The location should be level to prevent the unit or its
contents from accidentally falling, and strong enough
to support the weight of the unit and its contents.
!
For safe and proper operation, the unit must be
located a reasonable distance from combustible walls
and materials. If safe distances are not maintained,
discoloration or combustion could occur.
6
W
"
.5
A
(1 cm)
A
.422
(1 cm)
WARNING
CAUTION
Form No. HDWM-0399
"
.438
(1 cm)
H
"