Model Description; Model Designation; Specifications; Plug Configurations - Hatco HDW-R2 Series Installation And Operating Manual

MODEL DESCRIPTION

All Models
Hatco Split Drawer Warmers are built of rugged stainless steel
with heavy-duty full extension drawer slides and heavy-duty
hardware. These models are free-standing units equipped with
two, three, or four drawers, 2-1/2" (64 mm) deep food pans for
each drawer, 4" (102 mm) legs, and an attached 6' (1829 mm)
power cord with plug.
Each drawer features an adjustable temperature control and
temperature monitor. Drawers can be configured with or without
drawer vents. A single POWER ON/OFF (I/O) switch controls
the power to the unit. The insulated top and sides provide
maximum energy efficiency and the blanket heating elements
are warranted for one year. All drawer slides are warranted
against breakage for two years.

MODEL DESIGNATION

Drawer Warmer

SPECIFICATIONS

Plug Configurations

Units are supplied from the factory with an electrical cord and
plug installed.
WARNING
ELECTRIC SHOCK HAZARD: Plug unit into a properly
grounded electrical receptacle of the correct voltage,
size, and plug configuration. If plug and receptacle do not
match, contact a qualified electrician to determine and
install proper voltage and size electrical receptacle.
NOTE: The specification label is located on the back of the
unit. See the label for serial number and verification of
unit electrical information.
H D W - x R 2
Heated
Drawer
Vents
POWER ON/OFF (I/O) Switch
Quantity of Reduced/Split Drawers
per Full Size HDW Drawer
Reduced/Split Drawer Unit
Quantity of Full Size HDW Drawers
(for size identification)
Plug Configurations
NOTE: Receptacle not supplied by Hatco.
4
English
Temperature
Monitor
TEMPERATURE Control Knob
Model HDW-2R2
NEMA 5-15P
Form No. HDWR2M-0518