Table of Contents
Advertisement
VL1600 ProfiLe
LCD DISPLAY AND MENU SYSTEM OPERATION
The LCD Display Menu system consists of several categories. Use the Menu Buttons to access and make changes
to the menu items. When the desired menu item is reached, press the desired Menu Button to display the menu
options and to navigate and configure the menu options as required.
to navigate and access menu settings/selections:
Step 1.
Make sure unit is powered and turned on.
Step 2.
Press [ESC] to access menu categories.
Step 3.
Use four Arrow (◄▲▼►) buttons to navigate through the various options and settings.
Step 4.
Once menu item is reached, press [OK] to access the menu item parameters.
Step 5.
Make changes to parameters as desired.
Step 6.
Press OK [Enter] button to accept changes.
DmX aDDress
to set, edit, and save a DmX address:
Step 1.
Press [ESC].
Step 2.
Press [Up] / [Down] arrows until Address appears. Press [OK].
Step 3.
Use [Left] and [Right] arrow buttons to scroll through all digits.
Step 4.
Once at desired digit, use [Up] and [Down] arrows to change highlighted digit.
Step 5.
Once digit is set, use [Left] and [Right] arrow buttons to set other digits in DMX address.
Step 6.
Once all digits are set in DMX address, press [OK] to set.
Step 7.
DMX address will display and is saved.
OTHER LCD DISPLAY FEATURES
lCD menu BaTTerY OPeraTIOn
The LCD menu system utilizes a battery powered system for operation when the luminaire is not connected to
power. The primary purpose of this mode is to allow basic setup and configuration of the luminaire.
to enable the battery operation of the menu system:
Step 1.
Press and hold [ESC] and [OK] for two seconds.
Step 2.
Once enabled, the menu will function as normal.
NOTE: Any commands that require full power will be ignored while the menu system is in battery operation
mode.
Step 3.
To exit battery mode, press and hold [ESC] and [OK] for two seconds. Note, luminaire will automati-
cally exit this mode after one minute of inactivity.
sTaTus Bar
The Status Bar is present at all times and displays luminaire operational information of the luminaire. The Status
Bar contains the following information:
• LAMP – indicates current lamp state - ON or OFF.
• SHDN – indicates shutdown time in hours NO indicates NO shutdown time.
• ERRORS – Displays a number indicating the total amount of current errors.
When errors are present, messages will appear in Red text. When no errors
are present, NO will display.
• ADDR – Displays the current DMX address for the fixture.
NOTE: When the fixture does not detect a DMX input signal, the DMX address
text will display in Red text.
lCD menu PrOXImITY sensOr
The LCD menu system uses a proximity sensor to automatically enable the menu display (turn on the backlight)
as you reach for the front panel. If the display is off, it will turn on when your hand is within a few inches of the
display.
32
user manuaL
w w w.Va r i - L i t e .c o m
Advertisement
Table of Contents
