Dmx Operation - Vari Lite VL1600 Profile User Manual

VL1600 ProfiLe
crossed slot screw
(2 per head cover)
CAUTION: Do not push on gobo glass. Press on gobo carrier only.
CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or other covering while replacing. To
clean, refer to care aND maiNteNaNce oN PaGe
Step 5. Remove current gobo by carefully pressing on edges of gobo carrier with fingers, pressing gobo to-
ward front end of luminaire (toward lens), and out of wheel.
Step 6. Install new gobo as follows:
a.
b.
c.
Step 7. Rotate desired gobo wheel until required gobo position is accessible.

DMX OPERATION

DMX MAPS
The tables assume a DMX start address of 1. When a different starting address is used, this address becomes
channel 1 function and other functions follow in sequence.
gobo wheel
Place the gobo holder on a clean, flat work surface with the teeth facing upwards. The gobo is
held in place in the gobo holder by a spring. Taking care to avoid scratching or applying pressure
to the gobo, lever the end of the spring out, remove the spring and then lift the gobo out of the
gobo holder.
Hold the gobo with the dark side facing upwards towards the teeth in the gobo holder. Match up
the alignment marks (arrowed) in the gobo and gobo holder. Lay the new gobo flat in the gobo
holder.
Insert gobo carrier into wheel, ensuring that carrier snaps into place.
35.
16
user manuaL
w w w.Va r i - L i t e .c o m