Cleaning; Removing The Rotisserie Rack For Cleaning; Replacing The Rotisserie Rack; Draining The Reservoir - Hatco FLAV-R-SAVOR WFST-1X Installation & Operating Manual

The reservoir capacity permits uninterrupted operation
for approximately 3 to 6 hours, depending on the
settings and how frequently the door is opened. When
the red low water indicator lamp is lit, add water to the
reservoir.
WARNING:
To prevent electric shock, always unplug the Flav-R-
Savor Large Capacity Holding and Display Cabinet
before any cleaning or maintenance.
To preserve the bright finish of the Flav-R-Savor, it is
recommended that the exterior and interior surfaces be
wiped daily with a damp cloth. Food pans should be
removed and washed. The left rotisserie support and air
distribution duct are removable for cleaning. Stubborn
stains may be removed with a good stainless steel
cleaner or a non-abrasive cleaner. Hard to reach areas
should be cleaned with a small brush and mild soap.
CAUTION:
Abrasive cleaners could scratch the finish of your
Flav-R-Savor Large Capacity Holding and Display
Cabinet.
Clean the glass sides using a common glass cleaner.
REMOVING THE ROTISSERIE RACK FOR
CLEANING (MODEL WFST-1R)
1. Open the front access door.
2. Remove the five (5) wire baskets from the rotisserie
rack.
3. Lift left side of the rotisserie rack and move slightly
to left to disengage drive mechanism.
4. Remove rack from cabinet.

REPLACING THE ROTISSERIE RACK

1. Insert rotisserie rack with slotted drive plate on the
right side.
2. Engage drive plate into drive mechanism.
3. Place left side in slot.
4. Replace five (5) wire baskets.
The water reservoir refill capacity is approximately 48
ounces (1420 ml), or three (3) pints. Units with the
Auto-Fill option are filled automatically when the red
low water indicator lamp comes on.

DRAINING THE RESERVOIR

WARNING:
To avoid any injury, turn the power off to the unit
and allow to cool before draining.
NOTE: The drain hose assembly is located inside the
cabinet at the right front corner.
It is recommended that the Flav-R-Savor water reservoir
be drained prior to moving the cabinet and required after
removing lime or mineral deposits from the water
reservoir.
To drain the reservoir insert the drain fitting with hose
into the water outlet, located on the ceiling of the
cabinet. Once the fitting is installed, water will begin to
drain from the hose.
NOTE: Position a container to hold the water while
draining.
Once the unit has finished draining, the drain assembly
can be removed by pressing the release tab and gently
pulling the drain line out.
8
OPERATION

CLEANING

Form No. WFSTM-0297