Jamara CCX Pro Instructions Manual page 11

Functions
E POINT
With this setting you can set the steering angle of your servos. If your steering servo differs at full scale (left or right) differ, you can adjust it
with this setting.
Output value is 100%.
Displacements from 0 to 120%
Press „Enter" and select „E POINT" in the menu. To select the servo direction, press the channel (1, 2 or 3) ind the desired direction (1 = wheel,
2 = throttle, 3 = third channel key). Press „END" to enter the setting of the channel. Select with the rotary knob to set the value and press
Enter to confirm the value.
TRIM
With this setting you can set the neutral position of the servos.
Output value is N00
Setting of L30 to N00 to R30 and F30 to N00 and B30.
L = left, N = zero, R = Right, F = Forward B = Back
Press „Enter" and select „TRIM" in the menu. The channel will flash. Press „END" to enter the setting of the channel. Select with the rotary
knob to set the value and press Enter to confirm the value.
D/R
This setting allows you to limit the adjustment of the servo travel.
Output value is 100%
Displacements from 0 - 100%
Press „Enter" and choose „D / R" in the menu. The channel will
flash. Press „END" to enter the setting of the channel. Select with
the rotary knob to set the value and press Enter to confirm the
value.
11