Table of Contents
Advertisement
1.4 DISASSEMBLY OF 5 MONITOR ASSEMBLY
1.4.1 5 Monitor assembly/Hinge assembly
1. Remove the three screws (1 to 3) and then remove the
monitor cover by disengaging the two hooks (L5a, L5b)
at the top and bottom.
5
Note
a: Be careful not to lose part (Rib).
2. Pull out the part (sensor) from the monitor case assem-
bly.
3. Disconnect FPC from the connector CN5a and then re-
move the MONITOR board assembly and backlight.
5
Note
b: When removing the parts out of the monitor case
assembly, be very careful not to damage the FPC
and parts.
5
Note
c: Remove the MONITOR board assembly and
backlight together unless it is needed to separate
them from each other for part replacement, etc.,
because the two are soldered to each other.
4. Take out the LCD module, back light and monitor board
assembly from the monitor case assembly. Be careful
with the hooks (L5e, L5f) on the two sides.
Disconnect the FPC assembly from the connector
(CN5b) and remove the LCD module. Be careful with the
hooks (L5g ,L5h) on the two sides.
MONITOR
CASE ASSY
b
a
(L
5
f)
(L
LCD
MODULE
HINGE
COVER(L)
SENSOR
(L
c)
5
b
NOTE
5
e
HINGE
ASSY
(L
d)
5
FPC ASSY
NOTE
b,d,e,f
5
NOTE
NOTE
NOTE
BACK LIGHT
5
e)
(L
g)
5
c
4
(S
5
c)
HINGE
COVER(U)
5
MAGNET
(S
5
c)
5
d
d
5
MARKING
1.4.2 Hinge assembly
1. Remove the two screws (4,5) to take out the FPC assem-
bly while removing the hinge cover.
5
Note
d: Be careful not to lose any part during the above-
mentioned process.
2. Remove the hinge cover (U) from hinge assembly.
5
Note
e: Be careful not to lose any part during the abobe
mentioned process.
5
f: When reassembling, wind the FPC assembly
Note
around the hinge assembly by three turns and a
half.
Be careful not to break the FPC wire during the
work.
c
5
(L
h)
5
NOTE
5
c
MONITOR
BOARD
ASSY
(L
a)
5
CN
5
a
c
NOTE
5
a
RIB
a
CN
b
5
1
(S
a)
5
2
(L
(S
a)
5
Fig. 1-4-1
NOTE
c
5
<WIRING>
BROWN
BLACK
CN
5
b
RED
ORANGE
CN
5
a
NOTE
f
5
FPC ASSY
MONITOR
COVER
HINGE
ASSY
3
(S
b)
5
b)
5
1-8
Advertisement
Table of Contents
