Table of Contents
Advertisement
1.4 DISASSEMBLY OF 5 MONITOR ASSEMBLY
1.4.1 5 Monitor assembly/Hinge assembly
1. Remove the four screws (1-4). While opening the moni-
tor cover assembly as shown by the arrow, release the
two hooks (L5a, L5b) from engagement and remove
the monitor cover assembly.
2. Remove the parts out of the monitor case and unlock
the connector CN5a. While raising the hinge assem-
bly upwards, get the two hooks (L5c, L5d) disengaged
and disconnect the FPC by pulling it out. Then, remove
the hinge assembly.
5
Note
a: When removing the parts out of the monitor case
assembly, be very careful not to damage the FPC
and parts.
3. Disconnect FPC from the connector CN5b and then re-
move the MONITOR board assembly and backlight.
NOTE
d
5
FPC ASSY
HINGE
ASSY
1-8
HINGE
5
COVER(U)
(S
f)
5
6
(L
g)
5
(S
f)
5
NOTE
5
c
(L
f)
5
MAGNET
NOTE
a
5
(L
c)
5
FPC ASSY
NOTE
5
HINGE
ASSY
(L
d)
5
HINGE
COVER(L)
NOTE
5
c
INSIDE
MARING
Fig. 1-4-1
5
b: Remove the MONITOR board assembly and
Note
backlight together unless it is needed to separate
them from each other for part replacement, etc.,
because the two are soldered to each other.
4. Remove the LCD module.
1.4.2 Hinge assembly
1. Remove the two screws (5, 6). While releasing the two
hooks (L5f, L5g) from engagement, remove the hinge
cover (U).
5
Note
c: Be careful not to lose any part during the above-
mentioned process.
2. Draw the FPC assembly out of the hinge cover (L) and
then remove the FPC assembly from the hinge assem-
bly.
5
Note
d: When reassembling, wind the FPC assembly
around the hinge assembly by three turns and a
half.
Be careful not to break the FPC wire during the
work.
MONITOR
COVER ASSY
(L
(L
5
a)
1
(S
c)
5
2
(S
5
c)
NOTE
5
b
d
CN
5
NOTE
a
5
: 0.098N·m (1.0kgf·cm)
: 0.069N·m (0.7kgf·cm)
4
5
b)
(S
5
e)
3
(S
d)
5
MONITOR
CN
b
5
BOARD
ASSY
(L
5
e)
a
BACK
LIGHT
LCD
MODULE
MONITOR CASE
Advertisement
Table of Contents
