Advertisement
Quick Links
LZ SERIES
EMERGENCY LED EXIT
Service Questions Call: (800) 334-8694
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed, including
the following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
All servicing should be performed by qualified
personnel only.
Do not mount near any heat producing equipment.
Equipment should be mounted in locations and at
heights where it will not be readily subjected to
tampering by unauthorized personnel.
The use of accessory equipment not recommended
by the manufacturer may cause an unsafe condition.
Do not use this equipment for other than intended
use.
In Class I Division 2 locations, do not replace any
non-metallic hardware with metal hardware.
Contact authorized agent for factory replacement
parts.
In Class I Division 2 areas, install equipment in
accordance with appropriate NEC articles plus any
other applicable codes.
To avoid static discharge, do not attach any
ungrounded metal hardware to the enclosure.
Do not use this equipment
outdoors.
CLASS I DIV 2
HAZARDOUS LOCATION
GROUPS A, B, C, AND D
ZONE 2 GROUPS IIC, IIB AND IIA
CLASS II DIV 2 GROUPS F AND G
AND CLASS III DIV 1 AND 2
INSTALLATION AND OPERATING
INSTRUCTIONS
Install only grounded wiring systems to supply
this equipment.
Free installation area of hazardous atmospheres
before wiring equipment or servicing, this reduces
the risk of accidental explosion due to inadvertent
battery shorting during installation.
SAVE THESE INSTRUCTIONS
WARNING – Shut off AC power to branch
circuits to which units will be connected. All
wiring should be per N.E.C. wiring methods for
Hazardous locations.
To maintain warranty, equipment with batteries
must be installed or placed on charge within
prescribed period after shipment.
9140053441 Rev. 1
1
Advertisement
Related Manuals for Lithonia Lighting LZ Series
Summary of Contents for Lithonia Lighting LZ Series
- Page 1 GROUPS A, B, C, AND D ZONE 2 GROUPS IIC, IIB AND IIA CLASS II DIV 2 GROUPS F AND G AND CLASS III DIV 1 AND 2 LZ SERIES INSTALLATION AND OPERATING EMERGENCY LED EXIT INSTRUCTIONS Service Questions Call: (800) 334-8694...
- Page 2 9140053441 Rev. 1 INSTRUCTIONS – INSTALLATION 1. Mount exit enclosure to wall using (4) thru holes or optional mounting feet. (See Figure 3). 2. Remove cover screws (2) and open cover. (See Figures 1 and 2). 3. Dismount exit lens by removing lens screws (4). (See Figures 1 and 2). 4.
- Page 3 9140053441 Rev. 1 FIGURE 3 6. Chevron labels with self-adhesive backing are supplied. Apply label(s) to exit lens as necessary. 7. Remount exit lens using lens screws. Close cover and secure with cover screws. INSTRUCTIONS – OPERATION 1. Energize AC power to exit. Unit will initiate normal power-up sequence (See page 4).
- Page 4 9140053441 Rev. 1 SELF-DIAGNOSTICS SYSTEM OPERATION (EMERGENCY OPERATION UNITS ONLY) Normal Power-Up Sequence At power-up, the red and green LED indicators will alternately flash for one to two seconds. Next, the unit will go through a “Power-Up Quick Test” with the green LED flashing quickly. If no power-up faults were detected, the green LED will then flash slowly for up to 36 hours to indicate that the battery is charging.
- Page 5 9140053441 Rev. 1...