Lithonia Lighting LHXNY Installation Instructions

INSTALLATION INSTRUCTIONS
NEW YORK APPROVED STEEL EXIT/LIGHTING UNIT COMBO
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS
MAY RESULT IN DEATH, SERIOUS INJURY OR SIGNIFICANT PROPERTY
DAMAGE. For your protection, read and follow these warnings and instructions
carefully before installing or maintaining this equipment. These instructions
do not attempt to cover all installation and maintenance situations. If you do
not understand these instructions or additional information is required, contact
LITHONIA LIGHTING or your local LITHONIA LIGHTING distributor.
WARNING: RISK OF ELECTRIC SHOCK - NEVER CONNECT TO,
DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT IS ENERGIZED.
WARNING: RISK OF FIRE. Lamps are hot. Keep combustible material away
from hot parts. Observe lamp manufacturer's warnings, recommendations
and restrictions on lamp operation and maintenance. Make sure lamps are
correctly installed.
WARNING: DO NOT USE ABRASIVE MATERIALS, OR OTHER
SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE FIXTURE,
WHICH MAY RESULT IN PERSONAL INJURY.
WARNING: RISK OF PERSONAL INJURY. This product may have sharp edges. Wear gloves to prevent cuts or abrasions when
removing from carton, handling, installing and maintaining this product.
IMPORTANT SAFEGUARDS: When using electrical equipment, basic safety precautions should always be followed, including the following:
• Before wiring to power supply, turn off electricity at fuse or circuit breaker.
• Disconnect AC power and unplug battery before servicing.
• Consult your local building code for approved wiring and installation.
• Do not use outdoors.
• Do not let power supply cord touch hot surfaces.
• Do not mount near gas or electric heater.
• Do not install a damaged fi xture.
• This product must be installed in accordance with the applicable installation codes and ordinances.
• Proper grounding is required to ensure personal safety (where applicable).
• All service shall be performed by qualifi ed personnel. This product must be installed and maintained in accordance with the
applicable installation codes by a person familiar with the construction and operation of the product and the hazards involved.
• Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Do not use this equipment for anything other than its intended use.
CAUTION: Halogen cycle lamp(s) may be used in this fi xture. To avoid shattering, do not operate lamp in excess of rated voltage.
Protect lamp against abrasions and scratches and against liquids when lamp is operating. Dispose of lamps with care. Halogen lamps
operate at high temperatures. Do not store or place fl ammable materials near lamps.
WARRANTY Three Year: This three-year warranty covers any defect in manufacturing, provided the defect develops under normal and
proper use. This liability extends only to replacement of the defective part. Labor charges will be honored by the factory only with prior written
approval from an authorized post-sales representative.
PAGE: 1 of 2
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
LHXNY