Lithonia Lighting LXNY Quick Start Manual

LXNY
New York Approved Steel Exit Sign
CAUTION: For safety and proper operation, read and follow instructions carefully before installation.
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS: MAY RESULT IN DEATH, SERI-
OUS INJURY OR SIGNIFICANT PROPERTY DAMAGE – For your protection, read and follow these warnings and
instructions carefully before installing or maintaining this equipment. These instructions do not attempt to cover all
installation and maintenance situations. If you do not understand these instructions or additional information is
required, contact Lithonia Lighting or your local Lithonia Lighting distributor.
WARNING: RISK OF ELECTRIC SHOCK – NEVER CONNECT TO, DISCONNECT FROM OR SERVICE WHILE
EQUIPMENT IS ENERGIZED.
WARNING: RISK OF FIRE – Lamps are hot. Keep combustibles material away from hot parts. Observe lamp
manufacturer's warnings, recommendations and restrictions on lamp operation and maintenance. Make sure lamps
are correctly installed.
WARNING: DO NOT USE ABRASIVE MATERIALS, OR OTHER SOLVENTS. USE OF THESE SUBSTANCES
MAY DAMAGE FIXTURE, WHICH MAY RESULT IN PERSONAL INJURY.
WARNING: RISK OF PERSONAL INJURY – This product may have sharp edges. Wear gloves to prevent cuts or
abrasions when removing from carton, handling, installing and maintaining this product.
(WHERE APPLICABLE)
• Before wiring to power supply, turn off electricity at fuse or circuit breaker.
• Disconnect A.C. power and unplug battery before servicing.
• Consult your local building code for approved wiring and installation.
• Do not use outdoors.
• Do not let power supply cord touch hot surfaces.
• Do not mount near gas or electric heater.
• Do not install a damaged fixture.
• This product must be installed in accordance with the applicable installation codes and ordinances.
• Proper grounding is required to ensure personal safety. (WHERE APPLICABLE)
• All service shall be performed by qualified service personnel. This product must be installed and maintained in
accordance with the applicable installation codes by a person familiar with the construction and operation of the
product and the hazards involved.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Do not use this equipment for other than intended use.
CAUTION: Halogen cycle lamp(s) may be used in this fixture. To avoid shattering, do not operate lamp in excess of
rated voltage. Protect lamp against abrasions and scratches and against liquids when lamp is operating. Dispose of
lamps with care. Halogen lamps operate at high temperatures. Do not store or place flammable materials near lamps.
Warranty Three-Year
This three year warranty covers any defect in manu-
facturing, provided the defect develps under normal
and proper use. This liability extends only to replace-
ment of the defective part. Labor charges will be hon-
ored by the factory only with prior written approval
from an authorized Post Sales representative.
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
AND DELIVER TO OWNER AFTER INSTALLATION
One Lithonia Way, Conyers, GA 30012, Ph: 1-800-334-8694, Fax: 770-981-8141
EMCSA00746 REV A