Table of Contents
Advertisement
Carl Zeiss
Fig. 8
Control elements on the
Fluar Illuminator Z mot.
Fig. 9
Control elements on the HXP 200 C
illuminator
− Button in un-pressed position (remote): internal shutter switched by remote control, e.g. via foot
switch connected to the HXP 200 C or a CAN-HD15 cable to the EMS 3 controller.
Hour counter display with reset button (Fig. 9/3):
− Display shows current number of operating hours of the installed HXP 200 lamp.
− The HXP 200 lamp must be replaced after 2000 operating hours and the hour counter reset to zero
(see manufacturer's instructions)
− The Reset button resets the hour counter to zero
Display shutter open (Fig. 9/4):
− Display LED lights up when shutter is open
18
Operation
Control elements on the Fluar Illuminator Z mot.
435180-9060-701
4
OPERATION
4.1
Control elements on the Fluar
Illuminator Z mot.
Shutter button (Fig. 8/1):
− Opens and closes the internal shutter
− Integral LED lights up when shutter is open
Buttons 1 to 4 (Fig. 8/2):
− Swivel
the
corresponding
position into the beam path
− Integral LED lights up when this position is
swiveled into the beam path
If the cover is removed from the
reflector turret while the device is
switched on, the five buttons on the
control panel will flash. The turret can
only be rotated manually. The shutter
is closed.
4.2
Control elements on the HXP 200 C
illuminator
Intensity control dial (Fig. 9/1):
− Controls light intensity in stages 0; 12.5; 25; 50
and 100 %
Shutter button remote/open (Fig. 9/2):
− Button in pressed position (open): internal
shutter of HXP 200 C is open
Fluar Illuminator Z mot.
reflector
turret
05/2012
Advertisement
Table of Contents
