Table of Contents
Advertisement
PTO Gearbox
Check gearbox oil level on new machines prior to first use, top up if required before using
the machine. Replace gearbox oil after an initial 50 hours of use and thereafter at
annual or 500 hour intervals; whichever occurs earliest.
Gearbox Capacity (Machine builds ►05/16)
0.7 Litre SAE75W90 Fully Synthetic which meets the following minimum requirements;
Viscosity at 40°C, cSt, 100.0 min.
Viscosity at 100°C, cSt, 17.2 min.
Gearbox Capacity (Machines builds 06/16 ►)
0.6 Litre SAE75W90 Fully Synthetic which meets the following minimum requirements;
Viscosity at 40°C, cSt, 100.0 min.
Viscosity at 100°C, cSt, 17.2 min.
Gearbox Oil Replacement & Topping Up Procedure
Drainage of the gearbox for an oil change is via the drain plug which is located on the base
of the gearbox.
To refill gearbox or for 'topping up' remove filler and level plugs indicated in the illustrations
above and fill gearbox via the filler plug to a point where the oil starts to run out of the level
plug orifice. Replace both plugs and tighten securely.
37
Advertisement
Table of Contents
