Table of Contents
Advertisement
BEFORE USING THIS MACHINE YOU MUST:
▲
Ensure you read all sections of the operator handbook.
▲
Ensure the operator is, or has been, properly trained to use the machine.
▲
Ensure the operator has been issued with and reads the operator handbook.
▲
Ensure the operator understands and follows the instructions in operator handbook.
▲
Ensure the tractor front, rear and sides are fitted with metal mesh or polycarbonate
guards of suitable size and strength to protect the operator against thrown debris or
parts.
▲
Ensure tractor guards are fitted correctly, are undamaged and kept properly
maintained.
▲
Ensure that all machine guards are in position, are undamaged, and are kept
maintained in accordance with the manufacturer's recommendations.
▲
Ensure flails and their fixings are of a type recommended by the manufacturer, are
securely attached and that none are missing or damaged.
▲
Ensure hydraulic pipes are carefully and correctly routed to avoid damage by chaffing,
stretching or pinching and that they are held in place with the correct fittings.
▲
Always follow the manufacturer's instructions for attachment and removal of the
machine from the tractor.
▲
Check that the machine fittings and couplings are in good condition.
▲
Ensure the tractor meets the minimum weight recommendations of the machine's
manufacturer and that ballast is used as necessary.
▲
Always inspect the work area thoroughly before starting to note obstacles and remove
wire, bottles, cans and other debris.
▲
Use clear suitably sized warning signs to alert others to the nature of the machine
working within that area. Signs should be placed at both ends of the work site. (It is
recommended that signs used are of a size and type specified by the Department of
Transport and positioned in accordance with their, and the Local Highways Authority,
guidelines).
▲
Ensure the operator is protected from noise. Ear defenders should be worn and tractor
cab doors and windows must be kept closed. Machine controls should be routed
through proprietary openings in the cab to enable all windows to be shut fully.
▲
Always work at a safe speed taking account of the conditions i.e.: terrain, highway
proximity and obstacles around and above the machine. Extra special attention should
be applied to Overhead Power Lines. Some of our machines are capable of reach in
excess of 8 metres (26 feet) this means they have the potential to well exceed, by
possibly 3 metres (9' 9"), the lowest legal minimum height of 5.2 metres from the
ground for 11,000 and 33,000 volt power lines. It cannot be stressed enough the
dangers that surround this capability, it is therefore vital that the operator is fully aware
of the maximum height and reach of the machine, and that they are fully conversant
with all aspects regarding the safe minimum distances that apply when working with
machines in close proximity to Power Lines. (Further information on this subject can be
obtained from the Health & Safety Executive or your Local Power Company).
6
Advertisement
Table of Contents
