madVR Labs Envy Setup Manual page 9

● If you used the Automatic Picture Mode Selection discussed in section 2.0.3.1, you must use a Gamma
of 2.2. This is shown in the Graphic below.
● If you used the Manual Picture Mode Selection covered in section 2.0.3.2, you must use a Gamma of
2.4, or whatever Gamma is selected in that Picture Mode, as in the example shown in section 2.0.3.2.
4.0.1.2 HDR Flag
● If you used the Automatic Picture Mode Selection discussed in section 2.0.3.1, you must set this flag to
On. The Projector will then receive this Flag when HDR content is being played, and automatically
switch to the correct Picture Mode (User 4 or "HDR-Auto" as explained above).
● If you used the Manual Picture Mode Selection covered in section 2.0.3.2, you must set this to Off. As
explained in that section, you will then have to manually change to the Picture Mode you created for
HDR Content (in our example above, User 1, or "HDR-Manual"), or have your control system
programmed to select this automatically.
madVR Envy – JVC Setup Guide
Copyright © madVR Labs, LLC. All rights reserved.