madVR Labs Envy Setup Manual page 4

2.0.3 HDR Picture Mode Configuration
There are two approaches to setting up the JVC for playback of HDR content with the Envy. The first allows the
JVC to automatically select the correct Picture Mode whenever it receives an HDR signal. The second approach
requires the user to manually select the right Picture Mode, or to use a control system (e.g., Control4, Savant,
Crestron, RTI) to select the correct Picture Mode.
2.0.3.1 Automatic Picture Mode Selection
With Automatic Picture Mode Selection, the JVC automatically uses the settings configured for HDR content
when the Envy sends HDR. Therefore, we need to configure a Picture Mode with HDR10 as the "Content
Type". In this example, we use the "User 4" Picture Mode.
For the NZ7/RS2100, the Color Profile should be BT2020. For the NZ8/NZ9/RS3100/RS4100, use either BT2020-
Normal (no Cinema Filter) or BT2020-Wide (engaging the Cinema Filter), depending on your preference. Color
temperature should be set to 6500K.
Note: Using the Cinema Filter provides the widest possible Color Gamut and is therefore our general
recommendation, but this also reduces the brightness by around 25-30%.
madVR Envy – JVC Setup Guide
Copyright © madVR Labs, LLC. All rights reserved.