Projector Settings - madVR Labs Envy Setup Manual

1.0 Introduction
Welcome to the madVR Envy Setup Guide for the JVC NZ7, NZ8, and NZ9 (RS2100, RS3100, and RS4100) series
of laser projectors. This guide shows how to configure your projector for SDR (Standard Dynamic Range) and
HDR (High Dynamic Range) content, to get the best results from your Envy. This guide covers topics specific to
using the JVC with the Envy. For general JVC setup information, please refer to the JVC Owner's Manual.

2.0 Projector Settings

These first sections will deal with configuring the proper settings on the Projector itself. After this, we will
address the settings in the Envy.
2.0.1 Input Level and Color Space
First, we want to set the Input Level and Color Space for the projector. Having a defined setting most of the
time is desirable, as there are cases when the projector will use an incorrect setting if on "auto", resulting in
an inaccurate image. Set the Input level to "16-235 (Video)" and then set Color Space to "RGB".
Note: Most video sources use 16-235, and 0-255 is mainly used with output from a computer. It is important to avoid a
mismatch between the Source and the Display, so that black and white levels are correct.
2.0.2 SDR Picture Mode Configuration
The Envy does not require any special JVC settings to display SDR content, so you can use whatever you prefer.
One easy way to set up the JVC for displaying SDR content is to use the "Natural" Picture Mode, with Color
Profile on Auto, Color Temperature at 6500K, and a Gamma of 2.4. Other settings in this Picture Mode can be
set to your preference (Laser Level, Dynamic Control, etc.).
madVR Envy – JVC Setup Guide
Copyright © madVR Labs, LLC. All rights reserved.