madVR Labs Envy Setup Manual page 6

Lastly, in the Auto Picture Mode Selection menu, for the HDR10 entry, select "User 4" (or "HDR-Auto", or
whatever you named it). The JVC will then automatically select this Picture Mode whenever it sees an
incoming HDR signal, which requires a special setting in the Envy, as covered in section 4.0.1.2.
2.0.3.2 Manual Picture Mode Selection
the Envy intentionally sends HDR content inside an SDR container. This is because the content is
By default,
already tone mapped, and the content should not be tone mapped again by the JVC. Therefore, we need to
configure a Picture Mode to display this signal with the JVC settings we want used for HDR playback. For
example, we may wish to use a higher laser output mode for HDR content. To set the Manual Picture Mode
we wish to use, select "User 1", with the Content Type of "SDR", and a Gamma of 2.4 (or whichever Gamma is
chosen in the Envy's Transfer Function, addressed in section 4.0.1.2).
The Color Profile choice here is the same as with the Automatic method in section 3.1. For the NZ7/RS2100,
the Color Profile would be BT2020. For the NZ8/NZ9/RS3100/RS4100, use either BT2020-Normal (no Cinema
Filter) or BT2020-Wide (engaging the Cinema Filter), depending on your preference. Color Temp should be set
to 6500K.
madVR Envy – JVC Setup Guide
Copyright © madVR Labs, LLC. All rights reserved.