Assembly - Weslo CADENCE G 3.9 User Manual

ASSEMBLY

•• Assembly requires two persons.
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you  nish all assembly steps.
•• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
1. See the inset drawing. Pull out the indicated pin
(A) and raise the uprights (B) as shown.
2. Insert a rear stabilizer bar (C) into the left upright
(B). Attach the rear stabilizer bar with two M6 x
45mm bolts (D), two M6 washers (E), and two M6
nuts (F).
Attach the other rear stabilizer bar (not shown)
to the right upright (B) in the same way.
Tighten the knob (G) in the indicated location.
•• To identify small parts, see page 6.
•• Assembly requires the following tools:
the included hex keys
one adjustable wrench
To avoid damaging parts, do not use power tools.
1
B
2
G
B
C
D
7
A
B
A
E
F