Chapter 4 Installing A Network Module Or Interface Card; Installing A Network Module - Cisco 2600 Series Hardware Installation Manual

Hide thumbs Also See for 2600 Series:
Table of Contents

Advertisement

Installing a Network Module or Interface Card
This chapter describes how to install network modules in a Cisco 2600 Series router, and includes
information on installing either a WAN interface card or a voice interface card (VWIC) into the
appropriate network module. The chapter contains the following sections:
WAN and voice interface cards can be installed in the network module either before or after the
Note
network module is installed in the router chassis.

Installing a Network Module

The following instructions apply only to installing a network module in a modular router chassis slot.
You can install network modules in the chassis either before or after mounting the router, whichever is
more convenient.
Before installing a network module into the router chassis, turn OFF electrical power to the router
Warning
to avoid the risk of electrical shock to yourself or to the equipment. To see translations of the
warnings that appear in this publication, refer to the Regulatory Compliance and Safety
Information document that accompanied this device.
Unless the router is using a copy of the Cisco IOS Release 11.3(3)T or later release, you cannot
Tip
install an ISDN BRI network module (or ISDN BRI WAN interface card) into the same chassis as an
ISDN PRI network module.
The following tools are required or recommended for this task:
OL-2171-02
Installing a Network Module
Installing a WAN Interface Card
Installing a Voice Interface Card
ESD-preventive wrist strap
Number 1 Phillips screwdriver
Duct or electrical tape (for routers using a DC power supply only)
C H A P T E R
Cisco 2600 Series Routers Hardware Installation Guide
4
4-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents