Cisco Broadband Access Center Installation Manual page 47

Chapter 4 Installing in a Lab Environment
Enter the appropriate KDC Interface Address, FQDN, and Realm information and then press Enter.
Step 8
The program redisplays the KDC information and prompts you to confirm this information.
Press y and Enter to continue. The program prompts you to enter PacketCable properties. For example:
Step 9
Enter PacketCable properties
Enter KDC Realm Name
Enter IP Address for Primary DHCP []
Enter IP Address for Primary DNS []
Enter IP Address for Secondary DHCP []
Enter IP Address for Secondary DNS []
Enter the appropriate voice technology information. Keep in mind that the KDC Realm name you enter
Step 10
here must be the same as that entered in the previous screen.
Press Enter; the program redisplays the PacketCable Properties information and prompts you to confirm
Step 11
the information.
Press y and Enter to continue. The program prompts you to enter the shared secret password. This
Step 12
password is a token that a BACC server uses to authenticate communication with other BACC servers.
The default password is secret.
Step 13 Enter the password that you want to use for authentication among BACC servers. For example:
Shared Secret Password
Enter the password to be used for authentication
among the BPR servers.
If you are performing a lab installation, then the password will be used for
all the servers.
enter must be the same as the components previously installed.
Enter the Shared Secret Password [secret] secret
The program prompts you to confirm the password.
Enter the password again and press y to continue. The program then displays the installation parameters
Step 14
that you selected. For example:
Installation Parameters
This screen shows the installation parameters that you have chosen:
========== Confirmation ==========
The Lab/Demo Installation will install all components using the following
parameters:
Installation directory:/opt/CSCObpr
Is this correct (y/n/q/?)
Press y and Enter to install the lab software. The program displays a message when the installation is
Step 15
complete.
You use the administrator's user interface to configure your license keys. Refer to the Cisco Broadband
Note
Access Center for Cable Administrator's Guide for additional information.
OL-19105-01
If this is a component installation, then the password you
[yes]
Cisco Broadband Access Center for Cable Installation Guide 2.7
Installing in a Lab Environment Using the CLI
4-5