Table of Contents
Advertisement
Chapter 3
Installing Components
Installing the Key Distribution Center
To install the Key Distribution Center (KDC), complete the steps described in the
Startup Process" section on page
On the Installation Components screen, select the Key Distribution Center option, then click Next to
Step 1
continue; the Home Directory Destination screen appears.
Enter the pathname for the home directory, or click the Browse button to locate the desired directory.
Step 2
Note
Click Next. The installation program performs some validation and, prompts you to create the directory,
Step 3
if necessary, before displaying the Data Directory Destination screen.
Click Next and the Key Distribution Center Realm Name screen appears.
Step 4
Enter the appropriate information into the fields shown.
Step 5
Field Name
KDC Realm
KDC FQDN
KDC Interface Address
Click Next and the KDC Service Key and DPE screen appears.
Step 6
Note
Step 7
Enter a 6 to 20 character password (see the example below) and the fully qualified domain name
(FQDN), for each DPE, and then click Add. Continue to add additional DPEs as necessary.
Example KDC Password
12345678901234567890
Click Next when you are done. The Installation Parameters screen appears.
Step 8
After verifying that the parameters are correct, click Next to install BACC, or Back to modify the
Step 9
parameters. When installation is complete, the Installation Summary screen appears.
Click Finish to end the installation process and exit the installation program.
Step 10
OL-19105-01
2-2, then follow these steps:
The installation program does not ask for the home directory when it identifies that you are
installing BACC components on a computer that already has a BACC component installed on it.
Description
Specifies, using a unique name, the Kerberos realm. This must match the
realm set at the associated components.
Identifies the fully qualified domain name on which the KDC server is
located.
Specifies the interface (generally the IP address of the KDC server) on
which the KDC listens for requests.
The KDC requires a password for each DPE. This password must be entered at the corresponding
DPE and MUST match that entered for the KDC otherwise the DPE will not operate.
Installing Components Using the Graphical User Interface
Cisco Broadband Access Center for Cable Installation Guide 2.7
"Installation and
3-7
Advertisement
Table of Contents
