Table of Contents
Advertisement
Chapter 3
Installing Components
Field Name
Kerberos Realm Name
IP Address of Primary
DHCP Server
IP Address of Primary DNS
Server
IP Address of Secondary
DHCP Server
IP Address of Secondary
DNS Server
Step 12
Click Next. The Shared Secret Password screen appears.
Step 13
Enter and confirm the shared secret password.
Note
Click Next. The Installation Parameters screen appears. This screen identifies the values that you have
Step 14
entered in the previous screens. To modify any of the values entered click Back until the desired screen
appears.
Click Next. When the installation is complete, the Installed Components Summary screen appears. Click
Step 15
Finish to exit the installation program.
Configuring Extensions
After you install the BACC extensions to Network Registrar, you must configure the extensions. The
procedure described in this section makes these assumptions:
•
•
•
To configure extensions, follow these steps:
Log in as root to the Network Registrar server.
Step 1
At the command line, enter these commands:
Step 2
<NR_HOME>/usrbin/nrcmd -N admin -P changeme -b <
<BACC_HOME>/cnr_ep/bin/bpr_cnr_enable_extpts.nrcmd
Step 3
Enter these commands to reload the Network Registrar server:
/etc/init.d/nwreglocal stop
/etc/init.d/nwreglocal start
Alternatively, you can enter this command to reload the DHCP server alone:
OL-19105-01
Description
Specifies, using a unique name, the Kerberos realm. This must match the
realm set at the associated components.
Specifies the IP address of the voice technology primary DHCP server.
Specifies the IP address of the computer which is running the primary
DNS server.
Specifies the IP address of the voice technology secondary DHCP server.
Specifies the IP address of the computer which is running the secondary
DNS server; if that server is being used.
Use the shared secret password specified during the RDU installation.
The BACC component is installed in /opt/CSCObpr.
Network Registrar is installed in /opt/nwreg2.
The Network Registrar username is admin and the password is changeme.
Installing Components Using the Graphical User Interface
Cisco Broadband Access Center for Cable Installation Guide 2.7
3-5
Advertisement
Table of Contents
