Validating Extensions - Cisco Broadband Access Center Installation Manual

Installing Components Using the Graphical User Interface
<NR_HOME>/usrbin/nrcmd -N admin -P changeme "dhcp reload"
Be aware that you also must configure client-classes, scope selection tags, policies, and scopes before
Caution
you can use the Network Registrar server. See the Network Registrar User's Guide for information about
configuring these entities.

Validating Extensions

In the nrcmd program, run the following command and verify the output is the same:
nrcmd> extension list
100 Ok
dexdropras:
preClientLookup:
prePacketEncode:
Note The <BACC_HOME> and <BACC_DATA> values may be different in your installation.
Also in the nrcmd program, run the following command and verify the output is the same:
nrcmd> dhcp listextensions
100 Ok
post-packet-decode: dexdropras
pre-packet-encode: prePacketEncode
pre-client-lookup: preClientLookup
post-client-lookup:
post-send-packet:
pre-dns-add-forward:
check-lease-acceptable:
Cisco Broadband Access Center for Cable Installation Guide 2.7
3-6
entry = dexdropras
file = libdexextension.so
init-args =
init-entry =
lang = Dex
entry = bprClientLookup
file = libbprextensions.so
init-args = BACC_HOME=/opt/CSCObpr,BACC_DATA=/var/CSCObpr
init-entry = bprInit
lang = Dex
entry = bprExecuteExtension
file = libbprextensions.so
init-args =
init-entry =
lang = Dex
Chapter 3 Installing Components
OL-19105-01