Installing Components Using the CLI
The program prompts you to enter the home directory destination.
To accept the default home directory destination, /opt/CSCObpr/, press Enter; or enter another
Step 4
directory. For example:
Home Directory Destination
Home Directory Destination [/opt/CSCObpr]
The program then asks you to confirm the directory.
Press y and Enter to continue. The program prompts you to enter the data directory destination
Step 5
To accept the default directory, /var/CSCObpr, press Enter; or enter another directory. For example:
Step 6
Data Directory Destination
Data Directory Destination [/var/CSCObpr] /var/disk0/CSCObpr
Note
Press y and Enter to continue. The program prompts you to enter the host IP address and the listening
Step 7
port of the RDU.
Enter the IP address (or hostname) and listening port of the host where the RDU software is installed.
Step 8
The program prompts you to confirm this information. For example:
Regional Distribution Unit Host/Port
Enter the IP address and the listening port of the regional distribution unit (RDU)
associated with this installation.
Enter the Host/IP address and address of the listening port for the RDU.
RDU IP Address [doc-u5.cisco.com] 10.10.10.2
RDU Listening Port [49187]
========== Confirmation ==========
RDU Host:10.10.10.2
RDU Port:49187
Is this correct (y/n/q/?)
Press y and Enter to continue. The program prompts you to enter the name of the extension point
Step 9
provisioning group.
Enter the name of the Network Registrar extension point group. For example:
Step 10
Cisco Network Registrar Extension Point Provisioning Group
Enter the Cisco Network Registrar extension point provisioning group.
This a required field.
characters without spaces and not exceed 10 characters in length.
the BPR command-line tool to change this value after you complete this
installation.
Extension Point Provisioning Group [] group1
Cisco Broadband Access Center for Cable Installation Guide 2.7
3-12
By default, the installation program installs the data directory (BPR_DATA) on a different
directory than the home directory (BPR_HOME). Cisco Systems recommends that the data
directory be on a different physical disk than the home directory; for example
/var/disk0/CSCObpr. However, you can install the data directory on the same disk as the home
directory.
The value you specify must contain only
[yes] y
Chapter 3
Installing Components
alphanumeric
You can use
OL-19105-01