Removing An Sfp Module - Cisco 860 Series Hardware Installation Manual

Chapter 3 Connecting the Router
Figure 3-31
Caution Do not remove the optical port plugs from the SFP until you are ready to connect cabling.
Caution
Connect the network cable to the SFP module.
Step 2

Removing an SFP Module

Follow these steps to remove the SFP module from a Cisco 892F series router:
Disconnect all cables from the SFP.
Step 1
Because invisible laser radiation may be emitted from the aperture of the port when no fiber
Warning
cable is connected, avoid exposure to laser radiation and do not stare into open apertures.
Statement 70
The latching mechanism used on many SFPs locks the SFP into place when cables are connected. Do
Caution
not pull on the cabling in an attempt to remove the SFP.
Disconnect the SFP latch. See
Step 2
SFP modules use various latch designs to secure the module in the SFP port. Latch designs are not linked
Note
to SFP model or technology type. For information on the SFP technology type and model, see the label
on the side of the SFP.
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16193-07
Installing an SFP Module
Figure 3-32.
Connecting a Small-form-factor Pluggable Module
3-35