Table of Contents
Advertisement
If the required sensitivity is different from the default sen-
sitivity an asterix will be displayed above the cursor.
Ni
B
5,4
METAL
AREA
SENS
SPEED
For more information on sensitivity setting please refer
to section 10 „Sensitivity".
4.1.5 Calibration (CAL)
Press SET-key for positioning the cursor to CAL (12).
The current calibration (factor) is displayed on the
reading display while on the alpha-numerical display a
crossbar is shown on the position for "unit", i.e. the
calibration factor is indicated without unit.
Use ARROW-keys for setting calibration or select default
calibration by pressing CLEAR-key.
If the required calibration factor is equal to the default
calibration (factor 1,000), there will be an empty space
above the cursor and 1,000 for default value can be
read.
E-14
µm
CAL
UNIT
If you have selected a calibration factor other than
1,000, an asterix (*) appears on the alphanumeric
display. For more information on calibration please refer
to section 9 „Calibration".
1,000
Ni B 5,4
4.1.6 Measuring unit (UNIT)
Press SET-key for positioning the cursor to UNIT (11).
Use ARROW-keys for selecting metric (microns) or
American mode (mils).
If you press SET-key again, the cursor disappears. For
resetting the cursor to the first position (METAL) and
repeating the whole setting procedure, press SET once
more.
GalvanoTest 3000
START
THICKN
STOP
VOLTAGE
SET PRINT
mm²
STATSCLEAR
Physik
ElektroPhysik
Advertisement
Table of Contents
