Alamo BUSH HOG RMB 1660 Operator's Manual page 115

Reverse tractor squarely and centrally to the
machine set tractor lower links to a height that
will permit
attachment points.
A
djust top link to position the stabiliser tongue
for attachment to the tractors top link clevis.
NOTE: Alternative tongues for stabilisers are
IMPORTANT: Rear of stabiliser tongue should be as close as possible to the bottom of the
stabiliser slot with the machine at rest on the ground – if required change the stabiliser lower
attachment points and/or clevis attachment position to achieve this setting. This is a vital
requirement to ensure the tongue is located at the slots mid-point when the machine is raised to
the work position thus allowing float in each direction.
RMB 1660 01/22
© 2022 Alamo Group Inc.
ASSEMBLY
attachment to lower frame
Assembly Section 3-15
Reverse fully in to attachment points then
raise the tractor linkage until it locks onto the
lower link balls on both sides of the machine.
Attach stabiliser tongue to highest suitable
clevis position that does not interfere with or
foul tractor components secure with pin and
lock pin.