Inserting The Card Stack Into The Extrusion - Cisco 3200 Series Upgrade Manual

Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure

Inserting the Card Stack into the Extrusion

To insert the card stack into the extrusion, follow these steps:
Make sure that the LED cable is connected to the FESMIC.
Step 1
Step 2 Route the FESMIC LED cable over the top of the stack.
Step 3 Align each card's Wedge Loks so that the angles on the Wedge Loks match the angle of the Wedge Lok
rail.
Figure 2-9
1
Place the extrusion on a sturdy, flat surface with the I/O end cap side facing up.
Step 4
OL-15983-01
Figure 2-9 shows proper Wedge Lok alignment.
Wedge Lok Alignment
Wedge Lok alignment
2
1
2 Wedge Lok rail
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
1
2-11