Cisco 3200 Series Upgrade Manual page 32

Card Replacement Process
For a 3-WMIC configuration, connect cables to the wiring card as shown in
Figure 2-14
5
1 Connect FESMIC 10-pin FE1X cable to
WMIC 3.
3 Connect the FESMIC's 10-pin FE3X cable to
WMIC 1.
5
Connect the WMIC 2 24-pin cable to port J2
on the wiring card.
Route the 20-pin LED cable over the other cables to secure them, and connect the LED cable to port J5
Step 3
on the wiring card.
Cisco 3200 Series Router Hardware Upgrade Guide
2-16
3-WMIC Configuration
1
2
4
Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure
3
2 Connect the FESMIC 10-pin FE2X cable to
WMIC 2.
4 Connect WMIC 3 24-pin cable to port J3 on
the wiring card.
Figure 2-12.
OL-15983-01