What You Can Upgrade Or Replace; Required Tools - Cisco 3200 Series Upgrade Manual

Chapter 1 Introduction
For more information about the difference between the two versions of the wiring card, see Field Notice:
FN - 62845 at:
www.cisco.com/en/US/products/hw/routers/ps272/products_field_notice09186a00808fbc72.shtml

What You Can Upgrade or Replace

This guide describes how to upgrade or replace the following Cisco 3200 Rugged ISR components in
the field:
•
•
•
•
•
•

Required Tools

Before you start the process of upgrading or replacing Cisco 3230 Rugged Enclosure and Cisco 3270
Rugged Enclosure components, make sure you have the following tools available.
Tool
Straight slot screwdriver
Phillips screwdriver
Hex blades/bits (3/3-in.)
with adjustable torque
driver (2.5 to 6 in-lb)
Adjustable wrench
Socket wrench (3/8-in.)
OL-15983-01
WMICs
Cisco 3230 and 3270 MARCs
SMICs
FESMICs
MRPCs
SFP Modules
Description
Use this tool to adjust the spacing on the stack.
Use this tool to tighten the screws holding the wiring card.
Use this tool to loosen the screws holding the stack cards. This tool is also
referred to as an Allen wrench.
Use this tool to change out the radio connectors on the back of the
enclosure.
Use this tool to tighten the end caps.
What You Can Upgrade or Replace
Cisco 3200 Series Router Hardware Upgrade Guide
1-9