Installation; Installation Preparation - Redx RX Series User Manual

3 Installation

3.1 Installation preparation

a. Indoor installation only, IP32
b. Vertically mount only
c. Install in a ventilated location. There must be enough clearance to ensure that the module
operates in the optimal heat dissipation state.
d. Install at suitable distance from any restricted areas, please review Standard ASNZS5139
e. Install on a sturdy support surface
f. The location must support the weight and size of the module
g. The environmental temperature must be between 0 ° C and +50° C, and the relative humidity
between 0% and 90% (without condensation)
h. Check the fans in the unit regularly
i. Location shall be dry with adequate air flow (pollution level < 2) and without excessive dust
j. Wiring terminals require protective covers
k. Installation is prohibited in any of the following environments
high temperature
The minimum clearance between sides must be maintained at least 300mm
a. Installation location of the system should be easy for operator to turn off at any time;
b. Do not install the system near signal transmitter;
c. Do not install the system in the living area;
d. Do not install the system at location where children can easily access
Rev 20220610
rain
Figure 3-1 - Installation locations
RX2505PU
erosion
≥300mm
slope
≥300 mm
Page 14 of 32
fire