Removing The Cover - Cisco 2600 Series Installation Manual

Figure 1
To install the Cisco RPS adapter plate, you will also need the following tools and equipment (which
are not included):
•
Cisco 2600 series router
•
Medium-size Phillips screwdriver
•
ESD-preventive wrist strap
•
Antistatic bag (optional)
•
Wire cutters or scissors for cutting the cable tie-wraps (optional)

Removing the Cover

You must remove the chassis cover to access the internal power supply.
Warning
with a power switch, line voltages are present within the power supply even when the
power switch is OFF and the power cord is connected. For systems without a power
switch, line voltages are present within the power supply when the power cord is
connected.
Warning
removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker
on the panel board that services the DC circuit, switch the circuit breaker to the OFF
position, and tape the switch handle of the circuit breaker in the OFF position.
Cisco RPS Adapter Plate for Cisco 2600 series Routers
Adapter plate
Do not touch the power supply when the power cord is connected. For systems
Before performing any of the following procedures, ensure that power is
Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers
Removing the Cover
5