Cisco 2600 Series Installation Manual page 6

Cisco rps adapter plate installation
Hide thumbs Also See for 2600 Series:
Table of Contents

Advertisement

Removing the Cover
Take these steps to remove the chassis cover:
Step 1
Step 2
Step 3
Warning
contact with telephone-network voltages.
Warning
lightning activity.
Step 4
Step 5
Figure 2
Step 6
Figure 3
Step 7
6 Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers
Power OFF the router.
Attach an ESD-preventive wrist strap.
Disconnect all cables from the rear panel of the router.
Before opening the chassis, disconnect the telephone-network cables to avoid
Do not work on the system or connect or disconnect cables during periods of
Place the router so that the front panel is facing you. Remove the screws located on top
of the cover near the front edge.
Slide the cover away from you until the metal tabs on the side edges separate from the
chassis bottom, as shown in Figure 2.
Removing the Cover
POWER
RPS
ACTIVITY
Lift the front edge of the cover until it clears the front of the chassis, as shown in Figure 3.
Lifting the Cover
POWER
RPS
ACTIVITY
Lift the cover until it is free from the chassis and then set it aside.
Cisco 2600
SERIES
Cisco 2600
SERIES

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF