Preventing Electrostatic Discharge Damage; Required Tools And Equipment - Cisco 2600 Series Installation Manual

Required Tools and Equipment

Seul le système d'alimentation redondant Cisco (RPS modèle PWR600-AC-RPS) doit servir à
alimenter le dispositif externe.
Das externe Gerät darf nur mit einer redundanten Stromversorgung von Cisco, Modell
PWR600-AC-RPS, betrieben werden.
Para alimentar el dispositivo externo, usar exclusivamente el sistema de alimentación redundante
(redundant power system = RPS) Cisco, modelo PWR600-AC-RPS.

Preventing Electrostatic Discharge Damage

Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. It occurs when
electronic printed circuit cards are improperly handled and can result in complete or intermittent
failures. Always follow ESD prevention procedures when removing and replacing cards. Ensure that
the chassis is electrically connected to earth ground. Wear an ESD-preventive wrist strap, ensuring
that it makes good skin contact. Connect the clip to an unpainted surface of the chassis frame to
safely channel unwanted ESD voltages to ground. To properly guard against ESD damage and
shocks, the wrist strap and cord must be used correctly. If no wrist strap is available, ground yourself
by touching the metal part of the chassis.
Caution
should be between 1 and 10 megohms (Mohm).
Required Tools and Equipment
This kit includes the following items:
•
•
4 Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers
For safety, periodically check the resistance value of the antistatic strap, which
Cisco RPS adapter plate, shown in Figure 1
DC power rating label