Replacing The Cover - Cisco 2600 Series Installation Manual

Installing the Redundant Power Supply Adapter Plate
Figure 11

Replacing the Cover

Take the following steps to replace the cover:
Step 1
Step 2
Caution
one end and then the other, working back and forth; however, use care to prevent bending
of the chassis edges.
Step 3
Step 4
Step 5
Step 6
10 Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers
Reconnecting the Connectors
Six-pin
connector
Position the two chassis sections, as shown in Figure 2.
Referring to Figure 2, press the two chassis sections together and ensure the following:
•
The top section fits into the rear of the bottom section. The bottom section fits into the
front of the top section.
•
Each side of the top and bottom sections fits together.
To fit the two sections together, it might be necessary to work them together at
When the two sections fit together snugly, slide the chassis top so until it fits into the front
bezel.
Replace the cover screws. Tighten the screws to no more than 8 or 9 inches/pound of
torque.
Reinstall the chassis on the wall, rack, desktop, or table.
Reconnect all cables.